This is a scan of the tech data sheet found inside the dryer and contains the listings for the diagnostics and error messages.
DIAGNOSTIC MODE
1 Press the “cancel ‘ button to enter standby mode and enable diagnostic entry
2. Within 10 seconds after pressing “cancel”, press any button (but cancel ) to wake up the control.
3. Within 5 seconds of wake up, turn the selector knob to the far left cycle and press and hold the “cancel” and the far left button under the display simultaneously for 3 seconds to enter the Diagnostic Mode – (note: to save time at wake up, the welcome screen can be by passed by turning the selector knob).
4. Upon entering Diagnostic Mode, all lights should flash on and off.
5. The following steps can be cycled through by turning the selector knob clockwise: <see document for diagnostic table>